You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Note that some component values are amended from those described on the PCB
U10 should be 74HC74 and U13 should be 74HCT74
R2 may be supplied as 22K or 47K resistor array (either functions fine)
Construction comments
I generally find it easier to add components in height order with the least-high components being added first. This enables you to make use of gravity to hold components in place and avoids having to solder over a high component when trying to reach a lower one
I supply a single M2.5 x 18mm screw with an 11mm spacer for securing the Raspberry Pi zero
An external SD card is not yet supported in software but the hardware has positions for either a through-hole breakout-board from ProtoPic or a surface-mount connector (see the Bill Of Materials for details). Neither is supplied with the kit.