Add OpenSCAP compliance card to host details

[sbernhard]

The compliance card has

• Show last state
• Show Rule result of last report
• Show date of last report and link to last report
• Show how many policies. If you click on the Policy count you see all used policies and the source (host, hostgroup). Additionally, its possible to set / unset directly to host.

Card:

Modal view to assign / unassign policies. It shows host and host group assignments and allows to assign / unassign direct host assignments:

[sbernhard]

Needs to be rebased after #617 was merged

[sbernhard]

@Lukshio / @MariaAga do you have some thoughts about this?

[MariaAga]

@sbernhard Hi! we will look and review it, in these 2 weeks we dont have capacity because of other commitments, but we will probably have time after

[sbernhard]

@sbernhard Hi! we will look and review it, in these 2 weeks we dont have capacity because of other commitments, but we will probably have time after

Thanks @MariaAga. I think this can also improve #616, too :)

[sbernhard]

Rebased and tests are green again @MariaAga
Same as for the performance improvement in #614 (it has 2 commits, therefore the pipeline is red)

[michalgritzbach]

Hi @sbernhard @MariaAga, any update on this?

[MariaAga]

Hi, we are looking into reviewing this between our internal teams. I dont know when it will happen

[sbernhard]

Improved modal view so that it displays:

• no policy available -> if there is no polixy at all available
• All policies assigned -> if no policy can be selected because all are already used
• otherwise: Select Policy

[Lukshio]

@sbernhard I didn't check it to the detail, but is this something similar? #623

[sbernhard]

@sbernhard I didn't check it to the detail, but is this something similar? #623

The PR #623 is completely different.

This PR changes

• each host, in host details gets a openscap compliance card which shows some openscap details like the compliance state, when was the last last report received etc.
• adds a small form to add / remove policies to this individual host at the host details page.

I have just rebased. You should give it a try using the generated RPM :-)