Chevy Volt safety

board/safety.h

@@ -21,6 +21,7 @@ int controls_allowed = 0;
 #include "safety/safety_defaults.h"
 #include "safety/safety_honda.h"
 #include "safety/safety_toyota.h"
+#include "safety/safety_gm.h"
 #include "safety/safety_elm327.h"
 
 const safety_hooks *current_hooks = &nooutput_hooks;
@@ -46,6 +47,7 @@ typedef struct {
 #define SAFETY_HONDA 1
 #define SAFETY_TOYOTA 2
 #define SAFETY_TOYOTA_NOLIMITS 0x1336
+#define SAFETY_GM 3
 #define SAFETY_ALLOUTPUT 0x1337
 #define SAFETY_ELM327 0xE327
 
@@ -54,6 +56,7 @@ const safety_hook_config safety_hook_registry[] = {
   {SAFETY_HONDA, &honda_hooks},
   {SAFETY_TOYOTA, &toyota_hooks},
   {SAFETY_TOYOTA_NOLIMITS, &toyota_nolimits_hooks},
+  {SAFETY_GM, &gm_hooks},
   {SAFETY_ALLOUTPUT, &alloutput_hooks},
   {SAFETY_ELM327, &elm327_hooks},
 };

board/safety/safety_gm.h

@@ -0,0 +1,181 @@
+// board enforces
+//   in-state
+//      accel set/resume
+//   out-state
+//      cancel button
+//      regen paddle
+//      accel rising edge
+//      brake rising edge
+//      brake > 0mph
+
+// gm_: poor man's namespacing
+int gm_brake_prev = 0;
+int gm_gas_prev = 0;
+int gm_speed = 0;
+
+// silence everything if stock ECUs are still online
+int gm_ascm_detected = 0;
+
+static void gm_rx_hook(CAN_FIFOMailBox_TypeDef *to_push) {
+
+  uint32_t addr;
+  if (to_push->RIR & 4) {
+    // Extended
+    // Not looked at, but have to be separated
+    // to avoid address collision
+    addr = to_push->RIR >> 3;
+  } else {
+    // Normal
+    addr = to_push->RIR >> 21;
+  }
+
+  // sample speed, really only care if car is moving or not
+  // rear left wheel speed
+  if (addr == 842) {
+    gm_speed = to_push->RDLR & 0xFFFF;
+  }
+
+  // check if stock ASCM ECU is still online
+  int bus_number = (to_push->RDTR >> 4) & 0xFF;
+  if (bus_number == 0 && addr == 715) {
+    gm_ascm_detected = 1;
+    controls_allowed = 0;
+  }
+
+  // ACC steering wheel buttons
+  if (addr == 481) {
+    int buttons = (to_push->RDHR >> 12) & 0x7;
+    // res/set - enable, cancel button - disable
+    if (buttons == 2 || buttons == 3) {
+      controls_allowed = 1;
+    } else if (buttons == 6) {
+      controls_allowed = 0;
+    }
+  }
+
+  // exit controls on rising edge of brake press or on brake press when
+  // speed > 0
+  if (addr == 241) {
+    int brake = (to_push->RDLR & 0xFF00) >> 8;
+    // Brake pedal's potentiometer returns near-zero reading
+    // even when pedal is not pressed
+    if (brake <= 5) {
+      brake = 0;
+    }
+    if (brake && (!gm_brake_prev || gm_speed)) {
+       controls_allowed = 0;
+    }
+    gm_brake_prev = brake;
+  }
+
+  // exit controls on rising edge of gas press
+  if (addr == 417) {
+    int gas = to_push->RDHR & 0xFF0000;
+    if (gas && !(gm_gas_prev)) {
+      controls_allowed = 0;
+    }
+    gm_gas_prev = gas;
+  }
+
+  // exit controls on regen paddle
+  if (addr == 189) {
+    int regen = to_push->RDLR & 0x20;
+    if (regen) {
+      controls_allowed = 0;
+    }
+  }
+}
+
+// all commands: gas/regen, friction brake and steering
+// if controls_allowed and no pedals pressed
+//     allow all commands up to limit
+// else
+//     block all commands that produce actuation
+
+static int gm_tx_hook(CAN_FIFOMailBox_TypeDef *to_send) {
+
+  // There can be only one! (ASCM)
+  if (gm_ascm_detected) {
+    return 0;
+  }
+
+  // disallow actuator commands if gas or brake (with vehicle moving) are pressed
+  // and the the latching controls_allowed flag is True
+  int pedal_pressed = gm_gas_prev || (gm_brake_prev && gm_speed);
+  int current_controls_allowed = controls_allowed && !(pedal_pressed);
+
+  uint32_t addr;
+  if (to_send->RIR & 4) {
+    // Extended
+    addr = to_send->RIR >> 3;
+  } else {
+    // Normal
+    addr = to_send->RIR >> 21;
+  }
+
+  // BRAKE: safety check
+  if (addr == 789) {
+    int rdlr = to_send->RDLR;
+    int brake = ((rdlr & 0xF) << 8) + ((rdlr & 0xFF00) >> 8);
+    brake = (0x1000 - brake) & 0xFFF;
+    if (current_controls_allowed) {
+      if (brake > 255) return 0;
+    } else {
+      if (brake != 0) return 0;
+    }
+  }
+
+  // LKA STEER: safety check
+  if (addr == 384) {
+    int rdlr = to_send->RDLR;
+    int steer = ((rdlr & 0x7) << 8) + ((rdlr & 0xFF00) >> 8);
+    int max_steer = 255;
+    if (current_controls_allowed) {
+      // Signed arithmetic
+      if (steer & 0x400) {
+        if (steer < (0x800 - max_steer)) return 0;
+      } else {
+        if (steer > max_steer) return 0;
+      }
+    } else {
+      if (steer != 0) return 0;
+    }
+  }
+
+  // PARK ASSIST STEER: unlimited torque, no thanks
+  if (addr == 823) return 0;
+
+  // GAS/REGEN: safety check
+  if (addr == 715) {
+    int rdlr = to_send->RDLR;
+    int gas_regen = ((rdlr & 0x7F0000) >> 11) + ((rdlr & 0xF8000000) >> 27);
+    int apply = rdlr & 1;
+    if (current_controls_allowed) {
+      if (gas_regen > 3072) return 0;
+    } else {
+      // Disabled message is !engaed with gas
+      // value that corresponds to max regen.
+      if (apply || gas_regen != 1404) return 0;
+    }
+  }
+
+  // 1 allows the message through
+  return true;
+}
+
+static int gm_tx_lin_hook(int lin_num, uint8_t *data, int len) {
+  // LIN is not used in Volt
+  return false;
+}
+
+static void gm_init(int16_t param) {
+  controls_allowed = 0;
+}
+
+const safety_hooks gm_hooks = {
+  .init = gm_init,
+  .rx = gm_rx_hook,
+  .tx = gm_tx_hook,
+  .tx_lin = gm_tx_lin_hook,
+};
+